Aeg Dishwasher Not Turning On

The mains plug is not plugged in. A start time has been selected.

Aeg Dishwasher Common Error Codes

Reset the GFI if needed.

Aeg dishwasher not turning on. When the thermal fuse fails the control panel will not receive power. Door Not Latching Properly. Before you check the condition of rinse aid make sure the rinse aid chamber is not empty.

Make sure that there is no damaged fuse in the fuse box. Touch one probe to each terminal. Unplug the dishwasher and try plugging something else such as a lamp into the socket.

If the dishes are to. Dishwasher door drops down or opens by itself. The anti-flood system has been triggered.

Turn on your multitester to the X1000 setting. AEG cooktops have built-in automatic safety switch off. For dishwasher models with a delay start timer.

The anti-flood system has been triggered. Close the dishwasher door. Open the door and then close it again firmly.

A problem with the rinse aid or its dispensing cap can be one of the reasons why the machine is not drying the dishes properly. Be sure it is plugged in. Dishwasher does not switch on no light on the panel.

For more information see Dishwasher - Checking Fuse or Dishwasher - Reset Circuit Breaker. If your dishwasher starts up again by itself there is most likely a issue with the control board replace the main control board assembly. Dishwasher door does not close.

The appliance becomes too hot eg. Dishwasher emits clickingticking noise during cycle. Dishwasher door shifts up during a wash cycle.

If dishwasher is flashing and the programme is still not starting. The drain pump in the dishwasher runs con- tinuously even with the appliance switched off. The door of the dishwasher is not closed properly.

Close the tap then unplug from the mains and contact AEG Service Force. Pull the wires out by the connectors and label them with tape so you know which terminal they fit in. The thermal fuse is often located underneath the inner door of.

If the outlet the dishwasher plugs into is a GFI outlet make sure it has not tripped. You spill liquids or place something across the control panel for more than 10 seconds. If the dishwasher does not turn on by itself possibly replace either the console keypad or wire harnesses.

Antiflood operated in the baseturn appliance off and then lay it on its BACK and see if water pours outnow stand it up and retry itIf it does the same thing again in a short time you have a blockage or a leak and will have to strip it to find out where from. The thermal fuse is a safety device that keeps the dishwasher from overheating and protects the control board. You should receive a reading between 2000 and 3000 ohms.

Plug in mains plug. If the control panel still shows no signs of. When a saucepan boils dry or oil reaches above 300C.

Dishwasher door will not stay open. The appliance deactivates automatically if. The programme does not start.

The programme does not start. The cycle is not starting. When there is a problem with the rinse aid the dishes will not shed water properly.

A fuse in the houses wiring system is defective. If the delay start is set cancel. Dishwasher door will not close properly or is crooked.

Mains plug is not plugged in. Replace the unit with a new one. If not remove the motor by removing the retention screws.

The drain pump in the dishwasher runs continuously - even with the appliance switched off. If this works the problem will be with the dishwasher rather than the socket. Make sure that the mains plug is connected to the mains socket.

Close the tap then unplug from the mains and contact AEG Service Force. Dishwasher door is defective. Make sure that the appliance door is closed.

If your dishwasher does not light up or is not getting power check where the dishwasher plugs into the wall. Reset the fuse or circuit breaker in your home that provides power to the dishwasher. Make sure the dishwasher door is closed tightly and is latched correctly.

Aeg Dishwasher Common Error Codes